Screwdriver Rack Generator

About Screwdriver Rack Generator

Screwdriver Rack Generator makes a wall rack with a slot or hole for each of your drivers: pick them from Wiha's Phillips, slotted and Torx sizes or measure your own. Each opening takes the shaft with room from your printer, a cone seat holds the handle upright, and the spacing comes from the handles, so small and large drivers sit side by side without wasting room. It prints as it hangs, shelf down with no supports, cuts itself between openings into pieces that fit your bed, and screws or hangs on a French cleat.

The full guide: every step with pictures, examples, print settings, fixes and every setting.

Read the Screwdriver Rack Generator guide

Frequently asked questions

Slot or hole?
A slot is open at the front, so a driver's shaft slides in and a wide slotted tip does not need to pass. A hole holds a driver from every side; it is sized for the wider of the shaft and the tip.
My rack is longer than my printer's bed. What happens?
It cuts itself between two openings into the fewest pieces that fit, never through an opening, and every piece gets its own screws or cleat.
My drivers are not Wiha. Will they fit?
Measure the shaft and the handle and type them as "6 x 32" (shaft x handle), or add the tip for a wide slotted one: "6 x 9 x 32".
Do I need to install anything?
No. Screwdriver Rack Generator runs in the browser, and the geometry is built on your computer. It is free; you need a free NabiMakes account to download the files.

Related tools

All Workshop tools